Yes even with the measurements in that link you posted. Is that not true?Įven if i could ditch asio i am skeptical about the windows sq. I would like to use the Reveal plugin which afaik is vst. It would be a big time sink to mess with all that again. The music computer has alot of services turned off including the windows audio service and other things I am sure it relies on. Jplay and audionrvana come to mind.Īnyhow i really do need asio. But man i tried several and never could get them to actually work even if they had their own app. In 2021 one would think that should be every player. I thought about ditching the player but i need one that could be controlled by an iphone. Is there a 32 bit option or similar software? ![]() Some settings implied 32 bit but the driver was only 24 bit and would not work. I saw the 32bit options in voice meeter and tried them both with no luck. ![]() If not using ASIO (or any direct mode) then both are equivalent.Ĭlick to expand.Thanks a ton for the response. Least amount of latency and no Windows engine artifacts if using ASIO throughout in Option 1. This will allow any mode including ASIO to play to Voicemeeter virtual input from Foobar as the option above but will require a non-direct mode to connect the Outputs A1 and A2 within Voicemeeter to the USB devices.Įither of the options will work. ![]() In the EAPO Configuration Edtor for the Device Selection Control you can choose USB 1 and USB 2 to head the sections with different EQs for the two DACs. Option 2: Choose to install EAPO to USB1 and USB2 as I had suggested earlier. This will allow you to use any driver mode including ASIO to Voicemeeter virtual inputs and any driver mode including ASIO to the USB DACs. Then in the EAPO Configuration Edtor for the Device Selection Control you can choose Output A1 and Output A2 to head the sections with different EQs for the two DACs. Option 1: Choose to install EAPO to Output A1 and Output A2 as pictured in the screen shot above (note these options will appear in the Configurator only AFTER Voicemeeter has the Outputs A1 and A2 assigned to available devices, so Step 1 above must be completed first). After installing EAPO, in the EAPO Configurator (don't mix up the two options below, do one or the other) Install VoiceMeeter and test out the chain to play audio through both DACs without using EAPO.Ģ. Ok, two options clarified for Hidalgo so as not to confuse him!ġ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |